Homebrew420
Active Member
A quick question to see if anyone has tried it.
I was going to finalize my duct routing as in this top view picture (excuse the poor drawing). All of this is roughly 5-6' off the floor horizontal except from the silencer to the window where it drops 1'
My spur of the moment idea was to route it this way : out the floor (there is a 3" deep void, approx 2' wide that the air would escape from under the building) this way it would mask some of the noise further but I'm not sure how efficient this would be pushing warm air down.. any views or anyone tried it?
Thanks.
I was going to finalize my duct routing as in this top view picture (excuse the poor drawing). All of this is roughly 5-6' off the floor horizontal except from the silencer to the window where it drops 1'
My spur of the moment idea was to route it this way : out the floor (there is a 3" deep void, approx 2' wide that the air would escape from under the building) this way it would mask some of the noise further but I'm not sure how efficient this would be pushing warm air down.. any views or anyone tried it?
Thanks.